quick answer please

[newb503]

I put my stock carb back on my x18 for now with a modded exhaust. What does the needle need to be on the carb (5 cuts)? Ive tried and tried to get the bogging to go away but cant.

[tattoos666]

turn the air and gas mix 2.5 out and see if that helps

[newb503]

no i know that i just need to know where the needle clip inside the carb needs to be. which space out of the 5

[tattoos666]

well sometimes you got to find out cuz of cold or heat plays a roll try them all till you find the one that works for you.

[newb503]

well what its doing is when i shift then give it gas it will not go for a min then kick in and start going. Its idleing perfect

[tattoos666]

it sounds like you need to clean the carb and cheak your fuel filter.sometimes the fuel line will start to break down or your gas is old or is just trash in your gas that will clog the carb

[newb503]

it boggs when i get into high gear like right as im ready to shift it bogs and also right after i shift it bogs for like 2 sec the kicks in and starts moving


How should i clean it? steps please?

[tattoos666]

take your carb off and take the bottom off the carb the four screws and clean it out with parts cleaner or soak it in gas then get a flat head and take the jet off and spray some cleaner up in there and if you got a air gun it helps to air the hole carb out then put it all back.