Hugh Jass
02-16-2008, 10:34 AM
where can i get a book or at least a parts break down for our motors? i want to pull my motor out and lighten and balance and port some stuff in it. i need a break down of it all before i take it apart to be sure. im sure i can do it with out it but i would like to have it for a back up. i have gone through quite a few car motors and even one or two car auto trans so i know i can do it. i just have never taken apart a bike motor/trans before.
i know everyone is going to say dont waist my time doing this to a stock motor just to get a 125 or something but i want to see how fast i can get a stock 110. when i start putting it back together i might even see if i have enough for a 114 bbk for it but i dont think i will. all this will cost me is a gasket set i will be doing all the machine work my self so it will be a low cost mod that could net a descent power gain. with it the rotating assy balanced it would make it alot easer on the motor in the upper power band.
i know everyone is going to say dont waist my time doing this to a stock motor just to get a 125 or something but i want to see how fast i can get a stock 110. when i start putting it back together i might even see if i have enough for a 114 bbk for it but i dont think i will. all this will cost me is a gasket set i will be doing all the machine work my self so it will be a low cost mod that could net a descent power gain. with it the rotating assy balanced it would make it alot easer on the motor in the upper power band.